Don’t Be a Total Waster (of plastic) Calibrate Your Desktop 3D Printer Like A Boss Book 2

Owning a 3D printer can be very rewarding and can open the door to learning new skills

All you must do now is set it up to print those objects. Calibrating a desktop 3D printer can be difficult and time-consuming. But not anymore.
I will show you how, very easily, and without any prior knowledge.
I will explain how to calibrate your 3D printer so that it gives you fantastic results every time. Calibrating a 3D printer is not only about getting a level bed.
I will show how to easily set up
• X, Y and Z axis plus the extruder.
• Calibrate the correct steps per millimetre settings for all axis and the extruder.
• Install software that makes setting up your 3D printer a breeze.
• Bed levelling without the use of a Z probe.
• How to set up an Auto bed leveling probe the right way.
• How to use the Arduino IDE to safely flash your firmware.

I have three printers, all the information I have used within my books been thoroughly tested to make sure it’s precise and works first time.